Hall-sensor tip
Reads the switching magnetic field of a live winding through the part’s own housing.

A non-contact Hall-sensor pen. Engine running, tip on the part, one cylinder at a time. The one that stays dark is the one to pull.
HallSense™ tip
Every time a coil, injector, relay or solenoid is switched, its winding throws a pulse of magnetic field through its own housing. The Hall sensor in the translucent tip reads that pulse from the outside. No probing, no piercing, no connector pulled.
PulseRead™ readout
Both indicator lights on and a beep: the part is being pulsed, so the driver, the fuse, the wiring, the connector and the winding are all alive. Dark and silent: no pulse at the tip. Compare it to the cylinder next door and you know where to look.
DualRange™ sensitivity
Mode I for the strong field of an ignition coil. Mode II for the fainter pulse of a relay, an injector or a solenoid. Pick the mode, hold the tip against the body of the part, and check a known-good one first so you know what “good” looks like on that car.
Flashlight on the pen
Press the blue button and the tip lights the back of the bay. The coil you need is always the one behind the intake, in the dark.
WakeSense™ auto-sleep · two AAA
No signal for about twenty seconds and it sleeps on its own; bring it back to a live part and it wakes and reads. Two AAA batteries under the teal cap. A clip for the shirt pocket.

A misfire code tells you the cylinder. This tells you whether the coil on it is being fired. That’s the difference between one part and a parts bill.

The guessing game
P0304. Could be the coil, the plug, the injector, the wiring to any of them. The usual answer is the coil-swap: pull two coils, swap them, clear the code, drive it, read it again, repeat. Or buy a full set of coils and hope. Or pay the shop a diagnostic fee to tell you it was one coil. The pen skips to the question that matters: is this part being fired, yes or no.

Ignition coils
Coil-on-plug, coil packs, wasted-spark, the old single coil with a distributor: every one of them pulses a magnetic field through its housing when it fires. Mode I, engine running, tip against the top of each coil in turn. A good coil lights the pen every time. A coil that isn’t being fired, or a coil whose primary has died, stays dark.

Fuel injectors
Each injector is a little solenoid that clicks open on command. Mode II, engine running, tip on the injector body: lights and a beep mean the computer is pulsing it and the circuit to it is whole. A dead-quiet injector next to five live ones is a wiring, connector or coil-winding problem, not a plug problem.

Relays, solenoids, alternator, fans
A relay you can’t hear click under the dash noise. A purge solenoid. An idle valve. The alternator while it spins. The radiator fan when the engine gets hot. Anything that works by energizing a coil of wire throws a field, and the pen reads it while the part is live and being commanded. Key on, circuit commanded, Mode II, tip on the part.

The flashlight
Press the blue button and the tip throws a beam exactly where the tip is pointed, which is exactly where you’re looking. No headlamp, no phone in your teeth. One pen, one hand, the whole job.

DualRange™ sensitivity
Mode I is for the strong field of an ignition coil. Mode II turns the sensitivity up for the fainter pulse of a relay, an injector or a solenoid. High sensitivity also hears the part next door, so on a crowded fuel rail keep the tip against the body of the one you’re testing. Before you condemn anything, touch a known-good part on the same car: that’s your “good” reading. Then go find the one that doesn’t match.

Lives in the shirt pocket
Clip, cap, done. Out before the hood is all the way up.
Tells you / doesn’t tell you
A first check, not the last word: it finds the part that isn’t doing anything in about a minute; your meter, spark tester or scan tool confirms it. 30 days to decide it earns its pocket.
Ray M.
P0304 · six-cylinder pickup
★★★★★
One coil instead of six
Shop quoted all six coils plus the diagnostic. Engine idling, touched each coil: five beeped, number four stayed dark. Swapped that one coil and the code hasn’t come back. Paid for itself the first afternoon.
Customer reviewDana K.
Learning on an old sedan
★★★★★
Takes the guessing out of it
I’m not a mechanic. I can read a code and I can hold a pen against a coil. Did a good coil first like the page says, then the rest. Found the quiet one in two minutes. That’s a tool I’ll actually use.
Customer reviewLuis H.
Mobile tech
★★★★☆
Good first-pass tool, not a scope
Lives in my pocket for the quick go/no-go on coils and injectors before I pull the scope out. Four stars: on one deeply recessed coil I had to go to mode II and get right down on it. Does what it says, know what it doesn’t.
Customer reviewJenna P.
Bought for my husband
★★★★★
He used it the same weekend
The man is impossible to buy for. He had the mower apart Saturday and used this to figure out the solenoid wasn’t getting anything. Got the three-pack so his brother and his dad got one each. All three are in shirt pockets now.
Customer reviewTom B.
Boat, truck, tractor
★★★★★
Works on everything with a coil in it
Outboard, the diesel’s glow relay, the tractor’s fuel solenoid. If it’s got a winding and it’s supposed to be doing something, this tells me whether it is.
Customer reviewMarcus A.
Relay chaser
★★★★☆
Found the fuel pump relay wasn’t pulling in
Couldn’t hear the relay over the fan. Mode II, tip on top of it, key on: nothing. Tip on the relay next to it: beep. Swapped them, car started. Four stars because on high sensitivity it also hears the neighbor if you’re not right on it.
Customer reviewChris W.
Dark driveway, winter
★★★★★
The light on the tip is the whole trick
Rear bank of a V6, under the intake, 6 pm in January. The light is on the same end as the sensor, so wherever I point I can see. Found the dead coil without a helper.
Customer reviewSam G.
Skipped the diagnostic fee
★★★★★
Cheaper than one trip to the shop
Diagnostic fee alone would have been more than this pen. I confirmed the injector on cylinder two was dead quiet, replaced it, and the shop never saw the car. Batteries were in the box, which I didn’t expect.
Customer reviewPer cylinder, engine idling, tip on each coil, to find the one that isn’t firing.
Connectors unplugged, wires back-probed or pins pierced. It reads through the housing.
In the box. Auto-sleep after about twenty seconds keeps them alive all season.
One for the truck. Or one for every engine you keep running.
1 tester pen
Pen, pocket clip, 2 AAA batteries
$99.99$59.99
Buy 2, Get 1 FreeBest value
3 pens · $39.99 each · truck, boat, mower, or two buddies
$299.97$119.98
Straight answers
Yes, for coils and injectors: cranking or idling. The pen reads the pulse of a part that is being fired or commanded right now. A coil sitting on the bench, or a car with the key off, reads dark on every coil. For a relay, solenoid or fan, the circuit has to be on and commanding the part.
First touch a part you know is good on the same car: a coil that’s obviously firing, with the engine idling, tip pressed against its body, in mode I. If that lights the pen, the pen is fine and the dark part is your answer. If nothing lights anything, check the batteries and their polarity, and try mode II on a deeply recessed or heavily potted coil, tip right down on the housing.
High sensitivity hears everything nearby: the next injector on the rail, a fan motor, a plug wire. Drop to mode I for coils, and on mode II keep the tip against the body of the one part you’re testing. Compare neighbors: the odd one out is the story.
No. It tells you the coil is being fired and its primary is alive. A coil that fires at idle and breaks down under load will still beep. If the pen says every coil is firing and the misfire is still there, move on to a spark tester, a coil swap or a scope.
I for ignition coils, whose field is strong. II for relays, injectors and solenoids, whose pulse is fainter. O is off; the pen also sleeps by itself after about twenty seconds without a signal and wakes when it senses one.
Using it
The pen never touches a terminal: it reads from outside the part, so your hands stay off the ignition’s high-voltage side and nothing is back-probed. The engine bay is still a running engine: keep hands, sleeves and the pen clear of belts, pulleys, the fan and the exhaust, parking brake on, in park or neutral.
On the ordinary 12-volt side (relays, fans, solenoids), yes. Never on or near the orange high-voltage cables, the battery pack or the drive system. Those need trained hands and rated gloves, not a pen.
Anything with an ignition coil, an injector, a relay or a solenoid that is being commanded while you test. That covers most small engines, outboards and bikes. The three-pack exists because the truck, the boat and the mower all end up needing it.
No. It answers one question fast: is this part being pulsed right now. The scan tool gives you the cylinder, the pen points at the part, the meter or spark tester confirms it.
The offer
Choose the 3-pen option and you pay for two: $119.98 for three, $39.99 each. One for the truck, one for the boat or the mower, one for the brother who borrows tools and doesn’t bring them back.
Yes, two AAA in the box. Pull them if the pen will sit unused for months; that’s good practice with any AAA tool.
For anyone who fixes their own car, bike or mower, it’s the tool they’ll use the first weekend and keep in a shirt pocket. It ships in its own box.
Service & support
30 days from delivery. If it doesn’t earn its pocket, send it back for a refund of the purchase price.
Orders ship from our U.S. warehouse with free U.S. shipping. You’ll get tracking by email as soon as it’s on the way.
Message us with a photo and we’ll sort out a replacement. No forms, no arguing.
A non-contact Hall-sensor pen for coils, injectors, relays, solenoids, alternator and fans: tip on the part, lights and a beep, nothing unplugged. One for $59.99, or buy two and get the third free.
Add to cart — $59.99Free shipping across the contiguous United States
30-day money-back guarantee — if it doesn’t earn its pocket, send it back
Non-contact Hall sensor, two modes, flashlight — buy two pens, get one free